We would like to thank all visitors of our booths at this year's Semicon and Productronica and look forward to a successful cooperation!
We are glad to introduce our new partner GNR srl - Analytical Instruments Group
GNR develops, manufactures and distributes world-wide optical emission spectrometers, x-ray diffractometers and x-ray fluorescence instruments.
We are looking forward to present this to our customers.
We are glad to introduce our new partner Lumina Instruments.
Lumina Instruments develops and produce Optical Scanner for Thin Film Defects at the highest level.
We are looking forward to present this system to our customers.
The “dam & fill” process with two materials is mainly used in cases where a component needs to be protected with an optically-transparent encapsulant or if a conventional glob-top material is too viscous to flow around and underneath fine wires. Optically transparent encapsulants usually have a low viscosity. A dam is therefore applied around the component first to prevent the potting material from flowing all over the substrate.
Epo-Tek OG116-31 is a UV-curable epoxy. Due to its thixotropic nature it is often used as a dam. It can be cured with UV-light in a very short time. Afterwards the encapsulant – either also a UV-cure or a thermoset material - can be applied.
Epo-Tek OG198-55 has an even higher thixotropy than OG116-31.
Both products have an extraordinary chemical and humidity resistance and a high glass transition temperature (Tg >110°C).
As most UV-cure epoxies, both OG116-31 and OG198-55 are cationic products. Ionic polymerization is initiated by photo-generated ions. The cure process continues until all polymers are consumed. Generally, cationic products have the benefits of less shrinkage and higher adhesion over free radical cured systems and are not adversely impacted by an oxygen rich curing environment.
Find more information here Carrière
The VCA Optima series contact angle measurement systems incorporates lightweight design, easy assembly, and the latest Windows™ standards and user-friendly software. VCA-optima systems are suitable for research or quality control in R&D and process engineering. Systems range from the basic Optima to the fully equipped Optima XE. Features include dynamic capture capability, motorized syringe, surface energy analysis and pendant drop analysis, to name a few.
The pre-recording of the webinar is now available for those who were not able to listen in. You can register by clicking on the below link and view the presentation at your leisure.